LPG掺混比对DME柴油预混压燃发动机性能影响的试验研究

赵玉伟; 牛天林; 程培源; 汪映

doi:〗10.3969/j.issn.1001-2222.2018.06.004

车用发动机 >

2018 , Vol. 0 >Issue 6: 23

DOI: https://doi.org/〗10.3969/j.issn.1001-2222.2018.06.004

栏目

LPG掺混比对DME柴油预混压燃发动机性能影响的试验研究

赵玉伟 ,
牛天林 ,
程培源 ,
汪映

展开

（1.空军工程大学防空反导学院，陕西西安 710051；2.西安交通大学能源与动力工程学院，陕西西安 710049）

收起

Effects of LPG Blending Ratio on Performance 〖JZ〗of DMEDiesel Premixed Charge Compression Ignition Engine

ZHAO Yuwei ,
NIU Tianlin ,
CHENG Peiyuan ,
WANG Ying

Expand

(1.Air and Missile Defense College,Air Force Engineering University,Xi‘an 710051,China;2.School of Energy and Power Engineering,Xi’an Jiaotong University, Xi’an 710049,China)

Fold

摘要

针对二甲醚（DME）柴油双燃料预混压燃发动机在DME预混量较大工况下存在的爆震等问题，在一台2105柴油机上研究了液化石油气（LPG）掺混比对DME柴油双燃料发动机燃烧特性、燃油经济性以及排放特性的影响。随LPG掺混比（f_L）增大，双燃料发动机表现出如下性能变化趋势：DME低温、高温反应阶段放热率峰值减小，柴油扩散燃烧阶段放热率峰值增大，3个阶段放热率峰值相位均滞后；缸内最大燃烧压力和最高燃烧温度降低；压力升高率曲线滞后，f_L=50%时最大压力升高率较高；有效热效率η_et逐渐降低；NO_x排放呈现降低趋势。f_L为20%和33%时，颗粒数量浓度高于预混纯DME工况；f_L为50%时，颗粒数量浓度与预混纯DME工况相当。

关键词： 二甲醚; 预混压燃; 液化石油气; 掺混比; 燃烧特性; 排放特性

本文引用格式

赵玉伟 , 牛天林 , 程培源 , 汪映 . LPG掺混比对DME柴油预混压燃发动机性能影响的试验研究 [J]. 车用发动机, 2018 , 0(6) : 23 . DOI: 〗10.3969/j.issn.1001-2222.2018.06.004

Abstract

In order to solve the knock problem of DMEdiesel dual fuel premixed charge compression ignition engine with a great premixed mass of DME, the effects of LPG blending ratio on combustion characteristics, fuel economy and emission characteristics were experimentally investigated on a 2105 diesel engine. The results show that the peak of heat release rate decreases in the stage of DME low temperature and high temperature reaction and increases in the stage of diesel diffusion combustion and its correspondent phases postpone in the three stages with the increase of LPG blending ratio f_L.The maximum in cylinder pressure and temperature decrease. The rising edge of pressure rise rate curve delays and the maximum pressure rise rate reaches the highest when the blending ratio f_L is 50%.The effective thermal efficiency decreases and NO_xemission shows a decreasing trend. Compared with premixing with pure DME, the particle number emissions are different which are higher when f_L is 20% or 33% and are the same when f_L is 50%.

Key words： dimethyl ether; premixed charge compression ignition; LPG; blending ratio; combustion characteristics; emission characteristics

Options

摘要页面

文章导航

模态框（Modal）标题

摘要

本文引用格式

Abstract